Chamber filter press installation and commissioning process and precautions

2023-07-20

Chamber Filter Press installation and commissioning process and precautions
chamber filter press is a commonly used high-pressure equipment in China. It is widely used in chemical, pharmaceutical, food and other industries. During the installation and commissioning process, the correct process and precautions are crucial to the normal operation and performance of the equipment. It is very important, the editor of Jungong Machinery in this article will introduce the process and precautions of the installation and commissioning of the box Filter Press.
Chamber Filter press installation and commissioning process,
1. Site preparation and installation basis
Before installation, it is necessary to ensure that the site environment where the box Filter press is located meets the requirements, including flat foundation and clean environment. At the same time, prepare the required tools and equipment according to the size and weight of the equipment, and fix and install the equipment on a predetermined basis to ensure the stability and safety of the equipment.
2. Install the Filter Plate and connect the pipeline
According to the requirements of the equipment, install the filter plates in the correct order and method, including fixing the filter plates and sealing the filter cloth between the filter plates, etc. According to the process requirements of the equipment, connect the feed pipe, discharge pipe, washing pipe, discharge pipe, etc. pipeline, make sure that the pipeline connection is tight and there is no leakage.
3. Install the operating system and perform power connection
According to the requirements of the equipment, install and debug the operating system of the equipment, including the electrical control system, Hydraulic System, etc., carry out the necessary electrical wiring and debugging, and connect the box filter press with the required power source, such as motor or hydraulic station, etc. , to ensure that the device is functioning properly.
4 Debugging and operation and safety inspection
Debug and run the installed box filter press, verify whether the functions of the equipment are normal, adjust the relevant parameters and the operation mode of the equipment, and ensure that the equipment can work normally.
After the commissioning is completed, conduct a comprehensive safety inspection to ensure the safety performance and reliability of each part of the equipment and eliminate potential safety hazards.
Precautions for installation and commissioning of chamber filter press
1. Strictly abide by the operating procedures and pay attention to safety protection
Install and debug according to the operation manual and procedures of the equipment to ensure the standardization and consistency of the operation. During the installation and commissioning process, always pay attention to safety and take necessary protective measures to avoid accidental injury and equipment damage.
2. Pay attention to the balance of equipment and the effect of lubrication and sealing
When installing the equipment, ensure the balance of the equipment and avoid instability and vibration. Fully lubricate and seal the lubricating and sealing parts of the equipment to ensure the normal operation and sealing effect of the equipment.
3. Do a good job of parameter adjustment and system testing
According to the process requirements, reasonably adjust the relevant parameters of the alarm equipment, such as filter operation, filter speed, etc., to achieve a better separation effect. Both part and self can work normally
4. Regular maintenance of filter press equipment
After the installation and commissioning is completed, formulate a regular maintenance plan for the equipment, regularly inspect and maintain the equipment, and extend the service life of the equipment.

The above content is the introduction of the editor about the installation test process and precautions of the van filter press. Through reasonable installation leak test process and strict precautions, the normal operation and performance of the van filter press can be guaranteed, and it is for the enterprise. Operation and production assistance. If you want to know more information about Filter Presses, or have equipment procurement needs, please leave a message or contact us by phone.

Filter Press

Previous: Process and advantages of program-controlled automatic pull plate filter press for treating hospital wastewater Next: Causes and treatment methods of plate and frame filter press leakage